Economical Ball Bearing Turbine Flowmeters With 37 Degree Flare Fittings

FTB-200

Vedi tutti i modelli qui sotto

INVIA ORDINE

±½% of Reading Accuracy
Ball Bearing Design for Economy
Deflector Cones Stabilize Low Mass Rotor for Increased Bearing Life
NIST Traceable Calibration Certificate Included for Water

Contatori dell'acqua - Visualizza i prodotti correlati

Descrizione

Click on this link if you need more information about a Flow meter.

OMEGA™ FTB-201 Series turbine meters have male flared-end fittings for easy connections. They are built to meet the performance requirements of MS 33656, though they do not carry a military specification. These units come with a mating 2-wire connector and can be supplied with the integrally mounted signal conditioners, shown in the to-order table below, to provide 4 to 20 mA, 0 to 5V, and factored pulse outputs.

37° Flare Installation Kits
Proper application of a turbine Installation kits for turbine meters with 37° flare end fittings consist of two lengths of stainless steel tubing cut to a length appropriate for the upstream and downstream straight pipe runs and flared at one end. Mating sleeves and nuts are included. The kits can be conveniently butt-welded into the piping system. Flow straightening sections may be provided with the installation kit. These kits are available in tubing sizes from ½ to 2".

These turbine meters are intended for clean fluid service only; where there is any doubt concerning possible particulate impurities in the process fluid, strainers are recommended. In addition, when using these units for fluids with viscosities other than 1 centistoke, special calibrations and universal viscosity curves are available – consult OMEGA’s sales department.

**Ranges**
Model	Linear Flow Range (litres/min)	37° Flare Fittings	Max. Op. Pressure (Barg)	Length (mm)	Nom. K Factor Pulses/litre
FTB-201	1.3 to 13.2	¾-16 UNF-3A	344	62	3430
FTB-202	2.8 to 28.4	¾-16 UNF-3A	344	62	2640
FTB-203	4.7 to 36	¾-16 UNF-3A	344	62	1580
FTB-204	6.6 to 60	7/8-14 UNF-3A	344	70	1080
FTB-205	9.5 to 110	1 1/16-12 UNF-3A	344	83	580
FTB-206	15 to 227	1 5/16 -12 UNF-3A	241	89	170
FTB-207	23 to 352	1 5/8 -12 UNF-3A	206	99	110
FTB-208	30 to 492	1 7/8 -12 UNF-3A	155	111	60
FTB-209	57 to 850	2½-12 UNF-3A	120	121	32

Specifications
Accuracy: ±0.5% of reading
Repeatability: ±0.1% of reading
Temperature Range: -268 to 232°C
Maximum Intermittent Overrange: 150% of maximum range
Materials of Construction:
   Body: 304 SS
   Rotor: 17-4 PH SS
   Bearings: 440C SS
Installation Kits: 340 SS, 1.7 mm thick
Electrical: Two-wire connector included
Max Pressure Drop: 0.34 bar

Ordinare(Specificare il codice prodotto)

Codice prodotto/Desc.

Q.tá

Descrizione

FTB-201

€1.628,00

Stock: 8 settimane

Linear range water 1.3 to 13.2 l/m; End conections: 3/4-16UNF-3A liquid turbine flowmeters

FTB-202

€1.628,00

Stock: 1 settimana

Linear range water 2.8 to 28.5 l/m; End conections: 3/4-16UNF-3A liquid turbine flowmeters

FTB-203

€2.098,83

Stock: 8 settimane

Linear range water 4.7 to 36 l/m. End conections: 3/4-16UNF-3A liquid turbine flowmeters

FTB-204

€1.628,00

Stock: 9 settimane

Linear range water 6.6 to 60 l/m. End conections: 7/8-14 UNF-3A liquid turbine flowmeters

FTB-205

€1.628,00

Stock: 11 settimane

Linear range water 9.5 to 110 l/m. End conections: 1 1/16-12 UNF-3A liquid turbine flowmeters

FTB-206

€1.802,00

Stock: 8 settimane

Linear range water 15 to 227 l/m. End conections: 1 5/16-12 UNF-3A liquid turbine flowmeters

FTB-207

€1.917,00

Stock: 9 settimane

Linear range water 23 to 352 l/m. End conections: 1 5/8 -12 UNF-3A liquid turbine flowmeters

FTB-208

€1.969,00

Stock: 9 settimane

Linear range water 30 to 492 l/m. End conections: 1 7/8 -12 UNF-3A liquid turbine flowmeters

FTB-209

€2.320,00

Stock: 9 settimane

Linear range water 57 to 850 l/m. End conections: 2 1/2 -12 UNF-3A liquid turbine flowmeters

Signal conditioners. Order as a system if purchased with a turbine meter. Eg: SYS/FTB-201/FLSC-18B. Use table below to order

FLSC-18B