Descrizione
The CA150 has been discontinued. For a potential replacement, please see our full offering of multifunction calibrators here.
Vertical Handheld Calibrator
Easy-to-hold vertical body is
designed to make it intuitively easy
to operate, as individual functions
are accessed directly by pressing
assigned keys. The main body case
(sold separately) is designed to
make it easy to hold the CA150 in
one hand.
Simultaneous Source
and Measurement for
Process Devices
In conventional calibration
applications, multiple devices such
as a standard generator, dial
resistor and multimeter were
required. Now with a single CA150
unit, it is possible to perform
operation check at regular
inspection and maintenance of
thermocouples, RTDs and
instruments, as well as maintenance
and equipment diagnosis of process
devices such as transmitters,
thermostats and signal converters.
Loop Power Supply Function
It is possible to measure generated
current signals while supplying
loop power 24 Vdc from a two-wire
type transmitter (up to 22 mA DC).
Highly Accurate and
Multi-Functional Source
and Measurement
High Accuracy: 0.02% for the
source unit and 0.02% for the
measurement unit
Source and Measurement
Functions: DCV voltage, DC mA,
ohm, Frequency and temperature
(thermocouple, RTD) and 24 Vdc
power supply function for
transmitters
Memory Functions:
Setting Memory
This function saves/loads setting
conditions. Up to 21 data items can
be stored. Settings for (source/
measurement) functions, ranges,
generated values/measured values
as well as setting mode conditions
can be stored.
Data Memory
This function saves source and
measure values displayed. Up to
100 data items can be stored.
Storage date/time, (source/
measurement) functions, ranges
and generated values/measured
values can be stored. Stored data
can be checked on the display
of the main unit as well as
via communication.
† Tutti gli importi indicati in EUR
Nota: Comes with complete instruction manual, 6 “AA” batteries, carrying case, leads and terminal adaptor. (Temperature display default is °C, may be changed to °F - see page 12-1 of manual.)
Vicino
