Environmental and Tri-Axial Shock Data Loggers

OM-CP-SHOCK-Series

Nuovo

Environmental and Tri-Axial Shock Data Loggers

^€1.026,39 OM-CP-ULTRASHOCK-A

INVIA ORDINE

Compact size
3-axis shock
Temperature, humidity, pressure (OM-CP-ULTRASHOCK-A only)
Fully configurable measurements
Long life rechargeable battery
Large capacity event memory
Programmable start time
Real time operation
CE compliant
Separate low-g and high-g accelerometers

Registratori di dati - Visualizza i prodotti correlati

Descrizione

OM-CP-ULTRASHOCK-A

The OM-CP-ULTRASHOCK-A is a 3-axis shock / acceleration data logger with additional channels for temperature, humidity and barometric pressure. Each of the six channels may be made active or inactive as needed. Disabling channels will provide additional storage to the enabled channels. The OM-CP-SHOCK300 is a 3-axis shock / acceleration data logger. Each of the three channels may be made active or inactive as needed. Disabling channels will provide additional storage to the enabled channels.

The OM-CP-ULTRASHOCK-A and OM-CP-SHOCK300 are specifically designed for documenting dynamic environments such as moving vehicles, trucks, containers, ships, etc. The device is also valuable in characterizing environments such as production and assembly lines of delicate electronics, IC fabrication, communications and computer components.

The OM-CP-ULTRASHOCK-A and OM-CP-SHOCK300 contain two separate accelerometers to provide high sensitivity and accuracy up to 15g or higher levels of shock monitoring up to 300g. One of three operating ranges must be chosen during setup for a logging session. Those ranges are +/- 15g (low g accelerometer), +/- 100g and +/- 300g (high g accelerometer).

OM-CP-SHOCK300 Specifications

SHOCK
Accelerometer Type	MEMS Semiconductor
Acceleration Range (g)	±15 g	±100 g	±300 g
Acceleration Resolution (g)	0.02 g	0.05 g	0.2 g
Calibrated Accuracy (g)	±0.3 g	±2.0 g	±6.0 g
Sampling Rate	1000 Hz
Accelerometer Freq. Resp.	>1000 Hz (15 g) >500 Hz (100 g, 300 g)
Reading Rate	1024 Hz to 5 minutes, selectable in software.

OM-CP-ULTRASHOCK-A Specifications

TEMPERATURE
Sensor	Semiconductor
Range	-20 °C to +60 °C
Resolution	0.1 °C
Accuracy	±0.5 °C (+5 °C to +60 °C)
HUMIDITY
Sensor	Capacitive Polymer
Range	0 %RH to 95 %RH
Resolution	0.1 %RH
Calibrated Accuracy	±3 %RH (±2 %RH typical at 25 °C)
Specified Accuracy Range	+20 °C to +40 °C 25 %RH to 75 %RH
PRESSURE
Sensor	Semiconductor Strain Gage
Range	100 mbar to 1300 mbar
Resolution	0.05 mbar
Calibrated Accuracy	±1.5 mbar at 25 °C at 750 mbar
SHOCK
Accelerometer Type	MEMS Semiconductor
Acceleration Range (g)	±15 g	±100 g	±300 g
Acceleration Resolution (g)	0.02 g	0.05 g	0.2 g
Calibrated Accuracy (g)	±0.3 g	±2.0 g	±6.0 g
Sampling Rate	1000 Hz
Accelerometer Freq. Resp.	>1000 Hz (15 g) >500 Hz (100 g, 300 g)
Reading Rate	1024 Hz to 5 minutes for shock, selectable in software. Temperature, pressure and humidity sampled approx. every 2 seconds at intervals shorter than 2 seconds. Otherwise, sampled at the reading rate.

GENERAL
Memory	3,593,358 readings (598,893 per channel, all channels in use)
Start Modes	Software programmable immediate start or delay start, up to 6 months in advance
Real Time Recording	May be used with PC to monitor and record data in real time at a 1 second sample rate
Password Protection	An optional password may be programmed into the device to restrict access to configuration options. Data may be read out with the password.
Calibration	Digital calibration through software
Calibration Date	Automatically recorded within device
Battery Type	Internal Lithium Ion pack, charger included
Battery Life	90 days typical at 64Hz rate
Data Format	Date and time stamped gravities (g and mg), temperature (°C, °F, K, °R), humidity (%RH, mg/ml water vapor concentration), pressure (PSIA, inHg, mmHg, bar, atm, Torr, Pa, kPa, MPa)
IP Rating	IP64
Time Accuracy	10 seconds/month (at 0 °C to 50 °C)
Computer Interface	USB-C cable required (included) 1MBaud
Supported Software	Windows XP SP3/7/8/10
Software Compatibility	Standard Software version 4.2.15.0 or later Secure Software version 4.2.14.0 or later
Operating Environment	-20 °C to +60 °C, 0 %RH to 95 %RH non-condensing
Dimensions	3.4 in x 1.7 in x 1.3 in (86 mm x 43 mm x 33 mm)
Weight	8 oz (227 g)
Enclosure	Anodized aluminum
Approvals	CE compliant EMC Directive 2014/30/EU RoHS Directive 2011/65/EU

Ordinare(Specificare il codice prodotto)

Codice prodotto/Desc.

Q.tá

Descrizione

OM-CP-ULTRASHOCK-A

€1.026,39

Stock: 1 settimana

Temperature, Humidity, Pressure and Tri-Axial Shock Data Logger

OM-CP-SHOCK300

€950,53

Stock: 1 settimana

Tri-Axial Shock Data Logger

† Tutti gli importi indicati in EUR

Programma:

Download OM-CP-SHOCK-SERIES_software

Download OM-CP software